2009 Toyota FJ Cruiser RWDFACTORY OEM SERVICE PROCEDURE

Steering Angle Sensor: Inspection

  1. INSPECT STEERING ANGLE SENSOR 
    1. Check the steering angle sensor.

      If any of the following occurs, replace the steering angle sensor with a new one.

      • The surface of the steering angle sensor is cracked, dented or chipped.
      • The connector is scratched, cracked, or damaged.
      • The steering angle sensor has been dropped.
        Fig 1: Identifying Steering Angle Sensor
        G05112393Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.