Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Toyota FJ Cruiser RWDFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS CHART
| Part Tightened | N*m | kgf*cm | ft.*lbf |
|---|---|---|---|
| Front speed sensor x Steering knuckle | 8.3 | 85 | 73 in.*lbf |
| Front wheel | 112 | 1, 137 | 82 |
| Battery negative terminal x Battery | 3.9 | 40 | 35 in.*lbf |
| Rear speed sensor x Rear axle housing | 8.3 | 85 | 73 in.*lbf |
| Rear wheel | 112 | 1, 137 | 82 |
| Yaw rate and deceleration sensor x Body | 13 | 136 | 10 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.