Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Toyota Corolla XRS, AutomaticFACTORY OEM SERVICE PROCEDURE
How To Proceed With Troubleshooting
HINT:
*: Use the Techstream.
- VEHICLE BROUGHT TO WORKSHOPÂ
- CUSTOMER PROBLEM ANALYSISÂ
- Interview the customer and confirm the problem (See HOW TO PROCEED WITH TROUBLESHOOTING ).
- CHECK DTC AND FREEZE FRAME DATA*Â
- Check and record DTCs and Freeze Frame Data.
- Clear the DTCs and Freeze Frame Data (See DTC CHECK / CLEARÂ for DTC Check/Clear, and FREEZE FRAME DATAÂ for Freeze Frame Data).
- Reconfirm the DTCs.
- Reconfirm the DTCs based on the recorded DTCs and Freeze Frame Data (See
DTC CHECK / CLEARÂ for DTC Check/Clear, and
FREEZE FRAME DATAÂ for Freeze Frame Data).
HINT:
- When DTCs indicating a CAN communication system malfunction are output, repair the CAN communication system before repairing each corresponding sensor (See HOW TO PROCEED WITH TROUBLESHOOTING ).
- If any of the DTCs U0100/65, U0123/62, U0124/ 95, and U0126/63 is output together with a CAN communication DTC, first check the appropriate sensor for a momentary open circuit (See CHECK FOR INTERMITTENT PROBLEMSÂ ).
- Reconfirm the DTCs based on the recorded DTCs and Freeze Frame Data (See
DTC CHECK / CLEARÂ for DTC Check/Clear, and
FREEZE FRAME DATAÂ for Freeze Frame Data).
ResultÂ
RESULT CHARTResult Proceed to DTC is output A DTC is not output (Problem symptom does not occur) B DTC is not output (Problem symptom occurs) C B:Â GO TO STEP Â 5
C:Â GO TO STEP Â 6
A: Go to next stepÂ
- DIAGNOSTIC TROUBLE CODE CHARTÂ
- Proceed to Diagnostic Trouble Code Chart (See DIAGNOSTIC TROUBLE CODE CHARTÂ ).
NEXT:Â GO TO STEP Â 7
- SYMPTOM SIMULATIONÂ
- Proceed to Diagnosis System (See DIAGNOSIS SYSTEMÂ ).
- PROBLEM SYMPTOMS TABLEÂ
- Proceed to Problem Symptoms Table (See PROBLEM SYMPTOMS TABLEÂ ).
- CIRCUIT INSPECTION*Â
- IDENTIFICATION OF PROBLEMÂ
- REPAIR OR REPLACEMENTÂ
- CONFIRMATION TEST*Â
NEXT: ENDÂ
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
