SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2009CAMRY HYBRIDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM (HYBRID)INITIALIZATIONDTC P0607 CONTROL MODULE PERFORMANCEINSPECTION PROCEDURE
2009 Toyota Camry Hybrid

Inspection Procedure

2009 Toyota Camry HybridSECTION Inspection Procedure
  1. CHECK WHETHER DTC OUTPUT RECURS (IN ADDITION TO DTC P0607) 
    1. Connect Techstream to the DLC3.
    2. Turn the power switch on (IG).
    3. Turn the tester on.
    4. Clear the DTC.
    5. Turn the power switch off.
    6. Disconnect the auxiliary battery negative terminal and wait for 1 minute.
    7. Connect the auxiliary battery negative terminal.
    8. Turn the power switch on (IG).
    9. Enter the following menus: Powertrain / Engine / Trouble Code.
    10. Read the DTCs.

    Result 

    RESULT CHART

    Display (DTC output) Proceed to
    P0607 A
    No output DTC B

    B: CHECK FOR INTERMITTENT PROBLEMS 

    A: REPLACE HYBRID VEHICLE CONTROL ECU 

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.