Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
On-Vehicle Inspection
- INSPECTION THROTTLE BODY
- Inspect the throttle control motor for operating sound.
- Turn the ignition switch on (IG).
- When turning the accelerator pedal position sensor lever, check the running sound of the motor. The motor should be running smoothly without friction sounds.
If operation is not as specified, check the throttle control motor, wiring and ECM (See INSPECTION ).
- Inspect the throttle position sensor.
- Connect the Techstream to the DLC3.
- Turn the ignition switch on (IG).
- Check that the MIL does not light up.
- Turn the Techstream ON.
- Enter the following menus: Powertrain/Engine/Data List/Throttle Position.
- Depress the accelerator pedal. When the throttle valve is fully opened, check that the value of Throttle Position is within the specification.
Standard throttle valve opening percentage: 60 % or more
If operation is not as specified, check the throttle position sensor, wiring and ECM (See INSPECTION ).
- Inspect the throttle control motor for operating sound.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
