2009 Toyota Avalon XLSFACTORY OEM SERVICE PROCEDURE

Inspection Procedure

  1. CHECK MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY 
    1. Remove the multiplex network master switch with connector still connected.
    2. Measure the voltage of the wire harness side connector.

      Standard voltage 

      VOLTAGE SPECIFICATION

      Switch Condition Tester Connection Specified Condition
      H6-15 (PCT) - Body ground Window lock switch is OFF → ON 0 V → 2 V or less
      H6-13 (TX) - Body ground Ignition switch ON 10 to 14 V
      Fig 1: Identifying Multiplex Network Master Switch Assembly Connectors Terminals
      G05408239Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    NG: REPLACE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY 

    OK: Go to next step 

  2. CHECK WIRE HARNESS (MULTIPLEX NETWORK MASTER SWITCH - MULTIPLEX NETWORK SWITCH) 
    1. Disconnect the H6 and G6 connectors.
    2. Measure the resistance of the wire harness side connector.

      Standard resistance 

      RESISTANCE SPECIFICATION

      Switch Condition Tester Connection Specified Condition
      H6-15 (PCT) - G6-11 (PCT) Always Below 1 Ω
      H6-15 (PCT) - Body ground Always 10 kΩ or higher
      H6-13 (TX) - G6-2 (RX) Always Below 1 Ω
      H6-13 (TX) - Body ground Always 10 kΩ or higher

    NG: REPAIR OR REPLACE HARNESS AND CONNECTOR 

    Fig 2: Identifying H6 And G6 Connectors Terminals
    G05408240Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    OK : PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE 

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.