2009 Toyota Avalon XLSFACTORY OEM SERVICE PROCEDURE

Inspection Procedure

  1. CHECK WIRE HARNESS (MULTIPLEX NETWORK MASTER SWITCH - BATTERY AND BODY GROUND) 
    1. Disconnect the H6 connector.
    2. Measure the resistance and voltage according to the value(s) in the table below.

      Resistance 

      RESISTANCE SPECIFICATION

      Tester Connection Condition Specified Condition
      H6-1 (E) - Body ground Always Below 1 Ω

      Voltage 

      VOLTAGE SPECIFICATION

      Tester Connection Condition Specified Condition
      H6-7 (BW) - Body ground Always 10 to 14 V
      H6-6 (B) - Body ground Always 10 to 14 V
      H6-11 (IG) - Body ground Ignition switch OFF → ON 0 V → 10 to 14 V
      Fig 1: Identifying Multiplex Network Master Switch H6 Connector Terminals
      G05408217Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

    OK : PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE 

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.