2009 Toyota Avalon XLSFACTORY OEM SERVICE PROCEDURE

Defogger Relay: Inspection

  1. INSPECT RELAY 
    1. Remove the RR DEF relay from the engine room R/ B.
    2. Measure the resistance according to the value(s) in the table below.
      Fig 1: Identifying Defogger Relay Terminal
      G05006618Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Resistance 

      RESISTANCE SPECIFICATION

      Tester connection Condition Specified condition
      3 - 5 Always 10 kΩ or higher
      3 - 5 Voltage is applied between terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the relay.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.