Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Toyota Avalon LimitedFACTORY OEM SERVICE PROCEDURE
Typical Enabling Conditions
TYPICAL ENABLING CONDITIONS
| Monitor runs whenever following DTCs are not present | None |
Case 1:
TYPICAL ENABLING CONDITIONS
| Ignition switch | ON |
| Engine | Running |
| Battery voltage | 8 V or more |
| Starter | OFF |
Case 2:
TYPICAL ENABLING CONDITIONS
| Internal engine OFF timer (elapsed time from engine stop) | 10 to 300 minutes |
| Battery voltage | 8 V or more |
| Ignition switch | ON |
| Starter | OFF |
Case 3:
TYPICAL ENABLING CONDITIONS
| Internal engine OFF timer (elapsed time from engine stop) | 400 minutes |
| Battery voltage | 8 V or more |
| Ignition switch | ON |
| Starter | OFF |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.