Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Toyota Sienna CEFACTORY OEM SERVICE PROCEDURE
Service Data
SERVICE DATA REFERENCE CHART
| Fuel pressure | 304 to 343 kPa (3.1 to 3.5 kgf/cm2 , 44.1 to 49.7 psi) | |
|---|---|---|
| Fuel pressure: at fuel pressure remains for 5 minutes after engine has stopped | 147 kPa (1.5 kgf/cm2 , 21 psi) or more | |
| Fuel injector | ||
| Resistance | at 20°C (68°F) | 11.6 to 12.4 Ω |
| Injection volume | 84 to 100 cm3 (5.1 to 6.0 cu in.) in 15 seconds | |
| Difference between each injector | 16 cm3 (0.98 cu in.) or less | |
| Fuel drop | 1 drop or less in 16 minutes | |
| Fuel pump | ||
| Resistance | at 20°C (68°F) | 0.2 to 3.0 Ω |
| Fuel pump resistor | ||
| Resistance | at 20°C (68°F) | 0.30 to 0.34 Ω |
| Fuel sender gauge assembly | ||
| Resistance | Float Level F | 13.5 to 16.5 Ω |
| Float Level E - F | 13.5 to 414.5 Ω (Gradually changes) | |
| Float Level E | 405.5 to 414.5 Ω | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.