2008 Toyota Sequoia SR5, 5.7 Y, RWDFACTORY OEM SERVICE PROCEDURE

Inspection Procedure

  1. PERFORM INITIALIZATION 
    1. Initialize the power window regulator motor (See INITIALIZATION  ).
    2. Check if the power window AUTO UP/DOWN function operates (See OPERATION CHECK  ).

      OK: AUTO UP/DOWN function operates. 

    NG: Go to step 2 

    OK: END (PROBLEM DUE TO INITIALIZATION FAILURE) 

  2. CHECK MOVEMENT OF DOOR GLASS 
    1. Remove the installation bolt of the door glass and hold the glass by hand. When raising the glass by hand, check that the glass moves smoothly.
      NOTE:
      • Make sure that the door glass fits to the glass run properly.
      • Make sure that the glass run is not deformed, and does not have foreign matter.

      OK: Door glass moves smoothly. 

    NG: INSTALL DOOR GLASS AND/OR GLASS RUN PROPERLY 

    OK: REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (APPLICABLE LOCATION)  (See REMOVAL  )

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.