Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Inspection Procedure
- INSPECT FOR EXHAUST GAS LEAKÂ
- Allow the engine to idle.
- Check for exhaust gas leaks around the heated oxygen sensor.
OK:Â
No leakage from the heated oxygen sensor.Â
NG: REPAIR OR REPLACE EXHAUST GAS LEAKAGE POINTÂ
OK: Go to next stepÂ
- CHECK HEATED OXYGEN SENSORÂ
- Connect Techstream to the DLC3.
- Start the engine and turn the tester on.
- Warm up the engine at an engine speed of 2500 rpm for approximately 90 seconds.
- Select the following menu items: Powertrain / Engine and ECT / Active Test / Control the Injection Volume for A/F Sensor.
- Perform the Control the Injection Volume for A/F Sensor operation with the engine in an idling condition (press the RIGHT or LEFT button to change the fuel injection volume).
- Monitor the voltage outputs of the HO2 sensors (O2S B1S2) displayed on the tester.
HINT:
- The Control the Injection Volume for A/F Sensor operation lowers the fuel injection volume by 12.5% or increases the injection volume by 25%.
- Each sensor reacts in accordance with increases in the fuel injection volume.
Standard voltageÂ
VOLTAGE SPECIFICATIONTester Display (Sensor) Injection Volumes Voltages O2S B1S2 -12.5% Less than 0.4 V +25% More than 0.5 V
NG: REPLACE HEATED OXYGEN SENSORÂ
OK: Go to next stepÂ
- CHECK WHETHER DTC OUTPUT RECURS (DTC P0606)Â
- Connect Techstream to the DLC3.
- Turn the power switch ON (IG) and turn the tester on.
- Clear the DTC (See DTC CHECK / CLEARÂ ).
- Turn the power switch OFF and turn the tester off.
- Disconnect the battery negative terminal and wait for 1 minute.
- Connect the battery negative terminal.
- Start the engine.
- Perform the drive pattern.
- Warm up the engine.
- Accelerate the vehicle to 50 mph (80 km/h) and stop the vehicle.
- Drive the vehicle at 35 to 50 mph (60 to 80 km/h) for 5 minutes or more.
- Turn the tester on.
- Select the following menu items: Powertrain / Engine and ECT / Trouble Code.
- Read the DTCs.
ResultÂ
RESULT CHARTDisplay (DTC output) Proceed to P0606 A No output B
B: CHECK FOR INTERMITTENT PROBLEMSÂ
A: REPLACE ECMÂ
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
