Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Toyota Prius BaseFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS CHART
| Part Tightened | N.m | kgf.cm | ft.lbf |
|---|---|---|---|
| Front axle hub nut | 216 | 2200 | 159 |
| Front wheel set nut | 103 | 1050 | 76 |
| Rear wheel set nut | 103 | 1050 | 76 |
| Front axle assembly x Shock absorber assembly front | 153 | 1560 | 113 |
| Speed sensor front x Steering knuckle | 8.0 | 82 | 71 in.*lbf |
| Tie rod end sub-assembly x Steering knuckle | 49 | 500 | 36 |
| Suspension arm sub-assembly lower No.1 x Steering knuckle | 89 | 908 | 66 |
| Front disc brake caliper assembly x Steering knuckle | 137.1 | 1398 | 101 |
| Rear axle hub & bearing assembly x Rear axle beam | 61 | 622 | 45 |
| Steering knuckle x Lower ball joint assembly | 71 | 724 | 52 |
| Steering knuckle x Front axle hub | 56 | 571 | 41 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.