Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Fail-Safe Chart
If any of the following codes are recorded, the ECM enters fail-safe mode.
| DTC No. | Fail-safe Operation | Fail-safe Deactivation Conditions |
|---|---|---|
| P0031 P0032 P0037 P0038 |
Heater is turned OFF | Power switch OFF |
| P0100 P0102 P0103 |
Ignition timing is calculated from engine speed and throttle angle | "Pass" condition detected |
| P0110 P0112 P0113 |
Intake air temperature is fixed at 20°C (68°F) | "Pass" condition detected |
| P0115 P0117 P0118 |
Engine coolant temperature is fixed at 80°C (176°F) | "Pass" condition detected |
| P0120 P0122 P0123 |
Fuel cut intermittently and drive on motor mode | Power switch OFF |
| P0121 | Fuel cut intermittently and drive on motor mode | Power switch OFF |
| P0325 | Maximum ignition timing retardation | Power switch OFF |
| P0351 P0352 P0353 P0354 |
Fuel cut and drive on motor mode | Power switch OFF |
| P0657 | VTA is fixed at about 16% and fuel cut intermittently and drive on motor mode | Power switch OFF |
| P1115 P1117 P1118 |
Engine coolant temperature is fixed at 80°C (176°F) | "Pass" condition detected |
| P1120 P1122 P1123 |
Water valve position is fixed at position when DTC is detected | "Pass" condition detected |
| P2102 P2103 |
VTA is fixed at about 16% and fuel cut intermittently | Power switch OFF |
| P2119 | VTA is fixed at about 16% and fuel cut intermittently | "Pass" condition detected and power switch OFF |
| P3190 P3191 P3193 |
Drive on motor mode | Power switch OFF |
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.