Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Toyota Matrix XR, AutomaticFACTORY OEM SERVICE PROCEDURE
Skid Control Sensor: Installation
- INSTALL SKID CONTROL SENSOR
- Clean the contacting surface of the axle hub and a new speed sensor.NOTE: Do not stick any foreign objects to the sensor rotor.
- Place the speed sensor on the axle hub so that the connector makes the lowest position under the on-vehicle condition.
- Using SST and press, install the new speed sensor to axle hub.
SST 09214-76011
- Clean the contacting surface of the axle hub and a new speed sensor.
- INSTALL REAR AXLE HUB AND BEARING ASSEMBLY LH (See INSTALLATION )
- CONNECT SKID CONTROL SENSOR WIRE
- Connect the skid control sensor wire connector to the skid control sensor.
- INSTALL REAR BRAKE DRUM SUB-ASSEMBLY (for Drum Type)
- INSTALL REAR DISC (for Disc Type)
- INSTALL REAR DISC BRAKE CALIPER ASSEMBLY LH (for Disc Type)
- INSTALL REAR WHEEL
Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)
- INSPECT AND ADJUST REAR WHEEL ALIGNMENT
HINT:
See ADJUSTMENT
- CHECK ABS SPEED SENSOR SIGNAL
HINT:
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
