2008 Toyota Matrix Base, StandardFACTORY OEM SERVICE PROCEDURE

DTC Check / Clear

WARNING: This page is about a different car, the 2011 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK DTC 
    1. Connect Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Read the DTCs by following the directions on the tester screen.

      HINT: 

      Refer to Techstream operator's manual for further details.

  2. CLEAR DTC 
    1. Connect Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Erase the DTCs by following the directions on the tester screen.

      HINT: 

      Refer to Techstream operator's manual for further details.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.