2008 Toyota Matrix Base, StandardFACTORY OEM SERVICE PROCEDURE

Skid Control Sensor: Installation

  1. INSTALL SKID CONTROL SENSOR 
    1. Clean the contacting surface of the axle hub and a new speed sensor.
      NOTE: Do not stick any foreign objects to the sensor rotor.
    2. Place the speed sensor on the axle hub so that the connector makes the lowest position under the on-vehicle condition.
      Fig 1: Identifying Speed Sensor
      G05194992Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Using SST and press, install the new speed sensor to axle hub.

      SST 09214-76011 

    Fig 2: Identifying SST For Installing Speed Sensor To Axle Hub
    G05194993Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY LH  (See INSTALLATION )
  3. CONNECT SKID CONTROL SENSOR WIRE 
    1. Connect the skid control sensor wire connector to the skid control sensor.
    Fig 3: Identifying Skid Control Sensor Wire Connector
    G05194990Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. INSTALL REAR BRAKE DRUM SUB-ASSEMBLY (for Drum Type) 
  5. INSTALL REAR DISC (for Disc Type) 
  6. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY LH (for Disc Type) 
  7. INSTALL REAR WHEEL 

    Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf) 

  8. INSPECT AND ADJUST REAR WHEEL ALIGNMENT 

    HINT:

    See ADJUSTMENT

  9. CHECK ABS SPEED SENSOR SIGNAL 

    HINT:

    See TEST MODE PROCEDURE 

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.