2008 Toyota Matrix Base, AutomaticFACTORY OEM SERVICE PROCEDURE

On-Vehicle Inspection

  1. CHECK MASS AIR FLOW METER 
    NOTE:
    • Perform the MAF meter inspection according to the procedures below.
    • Only replace the MAF meter when the MAF value in the DATA LIST (with the engine stopped) is not within the normal operating range or there is foreign matter on the MAF meter platinum hot wire (heater).
    1. Read value using Techstream (MAF).
      NOTE:
      • Perform the inspection with the vehicle indoors and on a level surface.
      • Perform the inspection of the MAF meter while it is installed to the air cleaner case (installed to the vehicle).
      • During the test, do not use the exhaust air duct to perform suction on the exhaust pipe.
      1. Connect the Techstream to the DLC3.
      2. Turn the ignition switch to the ON position (do not run the engine).
      3. Turn the Techstream on.
      4. Select the following menu items: Powertrain / Engine and ECT / Data List / MAF.
      5. Wait 30 seconds, and read the values on the Techstream.

        Standard condition 

        TECHSTREAM VALUES

        Tester Display Condition Standard Condition
        MAF
        • Engine not running
        • 30 seconds after ignition switch is turned ON
        Below 0.48 g/sec.

        If the result is not as specified, replace the MAF meter.

        If the result is within the specified range, inspect the cause of the extremely rich or lean air fuel ratio.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.