2008 Toyota Matrix Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Service Data

1ZZ-FE STARTING SERVICE DATA SPECIFICATION

Starter assembly  
Specified current 90 A or less at 11.5 V
Starter relay assembly  
Resistance (3 - 5) Standard 10 kΩ or higher
Below 1 Ω (Apply battery voltage to terminals 1 and 2)
Magnetic switch resistance Terminal 50 - C 1 Ω or lower
Terminal 50 - Switch body 2 Ω or lower
Starter armature  
Resistance Segments 1 Ω or lower
Commutator-Armature coil 10 kΩ or higher
Commutator depth Standard 3.1 mm (0.122 in.)
Maximum 3.8 mm (0.150 in.)
Starter commutator end frame assembly  
Brush length Standard 9.0 mm (0.354 in.)
Minimum 4.0 mm (0.158 in.)
Resistance
Positive (+) brush - Positive (-) brush
Standard 10 kΩ or higher
Snap ring  
Length Maximum 5.0 mm (0.197 in.)
Ignition or starter switch assembly  
Resistance LOCK 10 kΩ or higher
ACC Below 1 Ω
ON Below 1 Ω
START Below 1 Ω
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.