Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Toyota Matrix Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Service Data
1ZZ-FE CHARGING SERVICE DATA SPECIFICATION
| Battery | ||
|---|---|---|
| Voltage | Standard | 12.5 to 12.9 V at 20°C (68°F) |
| Charging circuit without load | ||
| Amperage | Standard | 10 A or less |
| Voltage | Standard | 12.9 to 14.9 V |
| Charging circuit with load | ||
| Amperage | Standard | 30 A or more |
| Generator brush holder assembly | ||
| Brush length | Standard | 9.5 to 11.5 mm (0.374 to 0.453 in.) |
| Minimum | 4.5 mm (0.177 in.) | |
| Generator regulator assembly | ||
| Resistance | B and F | When the positive and negative poles of terminals F and B are switched over, there is a resistance of below 1 Ω in one direction but 10 kΩ or higher in the other direction |
| E and F | When the positive and negative poles of terminals F and E are switched over, there is a resistance of below 1 Ω in one direction but 10 kΩ or higher in the other direction | |
| Generator holder w/ rectifier | ||
| Resistance | Positive (+) and each rectifier terminal | When the positive and negative poles of the positive (+) terminal and each rectifier terminal are switched over, there is a resistance of below 1 Ω in one direction but 10 kΩ or higher in the other direction |
| Negative (-) and each rectifier terminal | When the positive and negative poles of the negative (-) terminal and each rectifier terminal are switched over, there is a resistance of below 1 Ω in one direction but 10 kΩ or higher in the other direction | |
| Generator rotor assembly | ||
| Resistance | at 20°C (68°F) | 2.1 to 2.5 Ω |
| Slip ring diameter | Standard | 14.2 to 14.4 mm (0.559 to 0.567 in.) |
| Minimum | 14.0 mm (0.551 in.) | |
| Generator rectifier end frame | ||
| Resistance | Coil wires | Below 1 Ω |
| Coil wire and body | 1 MΩ. or higher | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.