2008 Toyota Matrix Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Power Outlet Socket: Removal

  1. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle) (See  INSTALLATION  ) 
  2. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (See  REMOVAL  ) 
  3. REMOVE REAR CONSOLE BOX ASSEMBLY (See  REMOVAL  ) 
  4. REMOVE POWER POINT SOCKET ASSEMBLY 
    1. Turn the socket in the circumference direction as shown in the illustration, disengage the claw between the socket and the power point socket cover, and push out the socket to the room side.
      Fig 1: Turning Socket In Circumference Direction
      G05237186Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Align the socket with the notch on the power point socket cover, remove the power point socket assembly to the room side.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.