2008 Toyota Matrix Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Cigarette Lighter Assembly: Removal

  1. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle) (See  INSTALLATION  ) 
  2. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (See  REMOVAL  ) 
  3. REMOVE CIGARETTE LIGHTER COVER 
    1. Release the 2 fitting claws, remove the cigarette lighter cover.
      Fig 1: Identifying Claws Location
      G05237175Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE CIGARETTE LIGHTER ASSEMBLY 
    1. Remove the cigarette lighter knob and element assembly.
    2. Turn the socket in the circumference direction as shown in the illustration, disengage the claw between the socket and the cigarette lighter bezel stay, and push out the socket to the room side.
    3. Align the socket with the notch on the cigarette lighter bezel stay, remove the cigarette lighter assembly to the room side.
      Fig 2: Turning Socket In Circumference Direction
      G05237176Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.