Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Vehicle Stability Control System: Calibration
- DESCRIPTION
- After replacing the VSC relevant components or performing "Front wheel alignment adjustment", clearing and reading the sensor calibration data are necessary.
- Follow the chart to perform calibration.CALIBRATION REFERENCE CHART
Replacing Parts Necessary Operation Skid Control ECU Yaw rate sensor and acceleration sensor zero point calibration. yaw rate and acceleration sensor - Clearing zero point calibration data.
- Yaw rate sensor and acceleration sensor zero point calibration.
Front Wheel Alignment - Clearing zero point calibration data.
- Yaw rate sensor and acceleration sensor zero point calibration.
- CLEAR ZERO POINT CALIBRATION (USING SST CHECK WIRE)
HINT:
After replacing the yaw rate and acceleration sensor, make sure to clear zero point calibration data in the skid control ECU and perform zero point calibration.
- Clear the zero point calibration using the SST check wire.
SST 09843-18040
- Turn the ignition switch to the ON position.
- Using SST, connect and disconnect terminals TS and CG of the DLC3 4 times or more within 8 seconds.
- Check that the warning light indicates the normal system code.
- Remove the SST.
- Clear the zero point calibration using the SST check wire.
- PERFORM ZERO POINT CALIBRATION OF YAW RATE AND ACCELERATION SENSOR (USING SST CHECK WIRE)
HINT:
After replacing the ABS and TRACTION actuator assembly, make sure to perform yaw rate and acceleration sensor zero point calibration.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.