2008 Toyota Land CruiserFACTORY OEM SERVICE PROCEDURE

Diagnostic Trouble Code Chart

HINT:

  • If a trouble code is output during the DTC check, check the circuit indicated by the DTC.
  • Inspect the fuses and relays before investigating the trouble areas as shown in the table below.

    DTC Chart of ABS 

    DTC CHART OF ABS

    DTC Code Detection Item Trouble Area
    C0200/31  Front Speed Sensor RH Circuit
    • Front speed sensor RH
    • Speed sensor circuit
    • Speed sensor rotor
    • Sensor installation
    • Master cylinder solenoid (Skid control ECU)
    C0205/32  Front Speed Sensor LH Circuit
    • Front speed sensor LH
    • Speed sensor circuit
    • Speed sensor rotor
    • Sensor installation
    • Master cylinder solenoid (Skid control ECU)
    C0210/33  Rear Speed Sensor RH Circuit
    • Rear speed sensor RH
    • Speed sensor circuit
    • Speed sensor rotor
    • Sensor installation
    • Master cylinder solenoid (Skid control ECU)
    C0215/34  Rear Speed Sensor LH Circuit
    • Rear speed sensor LH
    • Speed sensor circuit
    • Speed sensor rotor
    • Sensor installation
    • Master cylinder solenoid (Skid control ECU)
    C0226/21  SFR Solenoid Circuit
    • SFRH or SFRR circuit
    • Master cylinder solenoid
    C0236/22  SFL Solenoid Circuit
    • SFLH or SFLR circuit
    • Master cylinder solenoid
    C0246/23  SRR Solenoid Circuit
    • SRRH or SRRR circuit
    • Master cylinder solenoid
    C0256/24  SRL Solenoid Circuit
    • SRLH or SRLR circuit
    • Master cylinder solenoid
    C0278/11  Open or Short Circuit in ABS Solenoid Relay Circuit
    • ABS2 fuse
    • ABS solenoid relay
    • ABS solenoid relay circuit
    • Master cylinder solenoid
    C0279/12  Short to B+ in ABS Solenoid Relay Circuit
    • ABS2 fuse
    • ABS solenoid relay
    • ABS solenoid relay circuit
    • Master cylinder solenoid
    C1202/58  Brake Fluid Level Low / Open Circuit in Brake Fluid Level Warning Switch Circuit
    • Brake fluid level
    • Brake fluid level warning switch
    • Brake fluid level warning switch circuit
    • Master cylinder solenoid (Skid control ECU)
    C1225/25  SMC Solenoid Circuit
    • SMCF circuit
    • Master cylinder solenoid
    C1226/26  SPC Solenoid Circuit
    • SREA circuit
    • Master cylinder solenoid
    C1227/27  SRC Solenoid Circuit
    • SREC circuit
    • Master cylinder solenoid
    C1228/28  STR Solenoid Circuit
    • STR circuit
    • Master cylinder solenoid
    C1235/35  Foreign Object is Attached on Tip of Front Speed Sensor RH
    • Front speed sensor RH
    • Speed sensor rotor
    • Sensor installation
    • Master cylinder solenoid (Skid control ECU)
    C1236/36  Foreign Object is Attached on Tip of Front Speed Sensor LH
    • Front speed sensor LH
    • Speed sensor rotor
    • Sensor installation
    • Master cylinder solenoid (Skid control ECU)
    C1238/38  Foreign Object is Attached on Tip of Rear Speed Sensor RH
    • Rear speed sensor RH
    • Speed sensor rotor
    • Sensor installation
    • Master cylinder solenoid (Skid control ECU)
    C1239/39  Foreign Object is Attached on Tip of Rear Speed Sensor LH
    • Rear speed sensor LH
    • Speed sensor rotor
    • Sensor installation
    • Master cylinder solenoid (Skid control ECU)
    C1241/41  Low Battery Positive Voltage
    • Battery
    • ECU-IG fuse
    • Charging system
    • Power source circuit (IG1)
    C1242/42  IG2 Power Source Circuit
    • Battery
    • IC regulator
    • Power source circuit (IG2)
    • IGN fuse
    C1243/43  Acceleration Sensor Stuck Malfunction
    • Yaw rate and G sensor
    • Yaw rate and G sensor circuit
    • CAN communication system
    C1244/44  Open or Short in Deceleration Sensor Circuit
    • Yaw rate and G sensor
    • Yaw rate and G sensor circuit
    • CAN communication system
    C1245/45  Acceleration Sensor Output Malfunction
    • Yaw rate and G sensor
    • Yaw rate and G sensor circuit
    • CAN communication system
    C1246/46  Master Cylinder Pressure Sensor Malfunction
    • Master cylinder pressure sensor
    • Master cylinder pressure sensor circuit
    • Stop light switch
    • Master cylinder solenoid
    C1249/49  Open in Stop Light Switch Circuit
    • Stop light switch
    • Stop light switch circuit
    • Rear combination light (stop light) assembly
    • Master cylinder solenoid (Skid control ECU)
    C1251/51  Open in Pump Motor Circuit Hydraulic brake booster pump motor circuit
    C1252/52  Brake Booster Pump Motor on Time Abnormally Long
    • Hydraulic brake booster pump motor
    • Hydraulic brake booster pump motor circuit
    • Accumulator pressure sensor
    C1253/53  Pump Motor Relay Malfunction
    • Hydraulic brake booster pump motor
    • Hydraulic brake booster pump motor circuit
    C1254/54  Pressure Switch Circuit
    • Hydraulic brake booster
    • Accumulator pressure sensor
    • Master cylinder pressure sensor
    C1256/56  Accumulator Low Pressure
    • Hydraulic brake booster
    • Hydraulic brake booster pump motor
    • Hydraulic brake booster pump motor circuit
    • Accumulator pressure sensor
    C1257/57  Power Supply Drive Circuit
    • Hydraulic brake booster pump motor circuit
    C1268/68  Transfer "L4" Position Switch Circuit
    • Transfer indicator (L4) switch
    • Transfer indicator (L4) switch circuit
    • Four wheel drive control ECU
    • ECM
    C1336/98  Zero Point Calibration of Acceleration Sensor Undone
    • Yaw rate and G sensor
    • Zero point calibration undone
    • Park/neutral position switch (P position) circuit
    • Master cylinder solenoid (Skid control ECU)
    C1337/37  Different Diameter Tire Malfunction
    • Speed sensor
    • Speed sensor rotor
    • Speed sensor circuit
    • Tire size
    C1381/97  Acceleration Sensor Power Supply Voltage Malfunction
    • Yaw rate and G sensor
    • Yaw rate and G sensor power source circuit
    • CAN communication system
    U0073/94  Control Module Communication Bus OFF Wire harness
    U0124/95  Lost Communication with Lateral Acceleration Sensor Module
    • Wire harness
    • Yaw rate and G sensor

    DTC Chart of VSC 

    DTC CHART OF VSC

    DTC Code Detection Item Trouble Area
    C1201/51  Engine Control System Malfunction Engine control system
    C1203/53  ECM Communication Circuit Malfunction ECM
    C1210/36  Zero Point Calibration of Yaw Rate Sensor Undone
    • Yaw rate and G sensor
    • Zero point calibration undone
    • Park/neutral position switch (P position) circuit
    • Master cylinder solenoid (Skid control ECU)
    C1223/43  ABS Control System Malfunction ABS control system
    C1231/31  Steering Angle Sensor Circuit Malfunction
    • Steering angle sensor
    • Steering angle sensor circuit
    • Steering angle sensor power supply
    • CAN communication system
    • Master cylinder solenoid (Skid control ECU)
    C1232/32  Stuck in Deceleration Sensor
    • Yaw rate and G sensor
    • Yaw rate and G sensor circuit
    • CAN communication system
    C1234/34  Yaw Rate Sensor Malfunction
    • Yaw rate and G sensor
    • Yaw rate and G sensor circuit
    • CAN communication system
    C1290/66  Steering Angle Sensor Zero Point Malfunction Steering angle sensor
    C1340/47  Center Differential Lock Circuit
    • Center differential lock switch
    • Center differential lock switch circuit
    • Four wheel drive control ECU
    C1380/64  Stop Light Control Relay Malfunction
    • BRK LP relay
    • BRK LP relay circuit
    • Master cylinder solenoid (skid control ECU)
    U0100/65  Lost Communication with ECM / PCM Wire harness
    U0114/38  Lost Communication with 4WD Control ECU
    • Power source circuit of four wheel drive control ECU
    • Four wheel drive control ECU
    • Four wheel drive control ECU branch wire or connector
    U0123/62  Lost Communication with Yaw Rate Sensor Module
    • Wire harness
    • Yaw rate and G sensor
    U0126/63  Lost Communication with Steering Angle Sensor Module
    • Wire harness
    • Steering angle sensor
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.