Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Inspection Procedure
- INSPECT BATTERYÂ
- Check the battery voltage.
Standard Voltage: 11 to 14 VÂ
NG: GO TO CHARGING SYSTEM (ON-VEHICLE INSPECTION)Â (See ON-VEHICLE INSPECTION )
OK: Go to Next StepÂ
- Check the battery voltage.
- INSPECT IGN FUSEÂ
- Remove the IGN fuse from the engine room relay block.
- Measure the resistance according to the value(s) in the table below.
Standard ResistanceÂ
STANDARD RESISTANCE SPECIFICATIONTester Connection Condition Specified Condition IGN fuse Always Below 1 Ω
NG: REPLACE IGN FUSEÂ
OK: Go to Next StepÂ
- INSPECT SKID CONTROL ECU (IG2 TERMINAL)Â
- Install the IGN fuse.
- Disconnect the A25 skid control ECU connector.
- Measure the voltage according to the value(s) in the table below.
Standard VoltageÂ
STANDARD VOLTAGE SPECIFICATIONTester Connection Switch Condition Specified Condition A25-1 (IG2) - Body ground Engine switch on (IG) 11 to 14 V
NG: REPAIR OR REPLACE HARNESS OR CONNECTORÂ
OK: Go to Next StepÂ
- INSPECT SKID CONTROL ECU (GND TERMINAL)Â
- Disconnect the A24 and A25 skid control ECU connectors.
- Measure the resistance according to the value(s) in the table below.
Standard ResistanceÂ
STANDARD RESISTANCE SPECIFICATIONTester Connection Condition Specified Condition A24-1 (GND1) - Body ground Always Below 1 Ω A24-32 (GND2) - Body ground Always Below 1 Ω A25-4 (GND3) - Body ground Always Below 1 Ω
NG: REPAIR OR REPLACE HARNESS OR CONNECTORÂ
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
OK: Go to Next StepÂ
- RECONFIRM DTCÂ
- Clear the DTC (See DTC CHECK/CLEARÂ ).
- Check if the same DTC is output (See DTC CHECK/CLEARÂ
).
HINT:
Reinstall the sensors, connectors, etc. and restore the previous vehicle conditions before rechecking for DTCs.
ResultÂ
RESULT REFERENCEResult Proceed to DTC is output A DTC is not output B
B: USE SIMULATION METHOD TO CHECKÂ (See HOW TO PROCEED WITH TROUBLESHOOTING )
A: REPLACE MASTER CYLINDER SOLENOIDÂ (See DISASSEMBLY )
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
