Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Toyota Land CruiserFACTORY OEM SERVICE PROCEDURE
Front Speed Sensor: Removal
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
- REMOVE FRONT WHEEL
- REMOVE FRONT SKID CONTROL SENSOR WIRE LH
- Disconnect the connector from the front speed sensor.
- Remove the bolt and harness clamp.
- Remove the nut and harness clamp.
- Remove the 2 bolts and 2 harness clamps.
- Disconnect the connector and then remove the bolt, harness clamp and sensor wire.
- REMOVE FRONT SPEED SENSOR LH
- Using a 5 mm hexagon wrench, remove the bolt and speed sensor from the knuckle.
NOTE: Pull out the sensor while trying as much as possible not to rotate it.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.