Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Front Speed Sensor: Installation
- INSTALL FRONT SPEED SENSOR LH
- Using a 5 mm hexagon wrench, install the speed sensor with the bolt.
Torque: 8.3 N*m (85 kgf*cm, 73 in.*lbf)
NOTE:- Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.
- While inserting the speed sensor into the knuckle hole, do not strike or damage the sensor tip
- After installing the speed sensor, make sure there is no clearance or foreign matter between the sensor stay part and the knuckle.
- Make sure there is no foreign matter attached to the speed sensor rotor.
- Using a 5 mm hexagon wrench, install the speed sensor with the bolt.
- INSTALL FRONT SKID CONTROL SENSOR WIRE LH
- Connect the connector.
- Install the harness clamp with the bolt.
Torque: 13 N*m (127 kgf*cm, 9 ft.*lbf)
NOTE:- When installing the clamp, do not twist the wire harness.
- Make sure the clamp rotation stopper touches the installation position.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.