2008 Toyota Land CruiserFACTORY OEM SERVICE PROCEDURE

Crawl Switch: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  2. REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION  (See REMOVAL )
  3. REMOVE LOWER INSTRUMENT PANEL PAD SUBASSEMBLY LH  (See REMOVAL )
  4. REMOVE NO. 1 INSTRUMENT PANEL FINISH CUSHION  (See REMOVAL )
  5. REMOVE LOWER INSTRUMENT PANEL PAD SUBASSEMBLY RH  (See REMOVAL )
  6. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY  (See REMOVAL )
  7. REMOVE LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY  (See REMOVAL )
  8. REMOVE REAR UPPER CONSOLE PANEL SUBASSEMBLY  (See REMOVAL )
  9. REMOVE CONSOLE CUP HOLDER BOX SUB-ASSEMBLY  (See REMOVAL )
  10. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY  (See REMOVAL )
  11. REMOVE SUSPENSION CONTROL SWITCH (CRAWL SWITCH) 
    1. Disconnect the connector.
    2. Detach the 4 claws and remove the suspension control switch (CRAWL switch) from the upper console panel.
    Fig 1: Locating Suspension Control Switch
    G05630000Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.