Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Toyota Land CruiserFACTORY OEM SERVICE PROCEDURE
Crawl Switch: Installation
- INSTALL CRAWL SWITCHÂ
- Attach the 4 claws to install the suspension control switch (CRAWL switch).
- Connect the connector.
- INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLYÂ (See INSTALLATION )
- INSTALL CONSOLE CUP HOLDER BOX SUBASSEMBLYÂ (See INSTALLATION )
- INSTALL REAR UPPER CONSOLE PANEL SUBASSEMBLYÂ (See INSTALLATION )
- INSTALL LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLYÂ (See INSTALLATION )
- INSTALL SHIFT LEVER KNOB SUB-ASSEMBLYÂ (See INSTALLATION )
- INSTALL LOWER INSTRUMENT PANEL PAD SUBASSEMBLY RHÂ (See INSTALLATION )
- INSTALL NO. 1 INSTRUMENT PANEL FINISH CUSHIONÂ (See INSTALLATION )
- INSTALL LOWER INSTRUMENT PANEL PAD SUBASSEMBLY LHÂ (See INSTALLATION )
- INSTALL NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHIONÂ (See INSTALLATION )
- CONNECT CABLE TO NEGATIVE BATTERY TERMINALÂ
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
