2008 Toyota Land CruiserFACTORY OEM SERVICE PROCEDURE

Rear Power Window Switch: Installation

HINT:

  • Use the same procedures for the LH side and RH side.
  • The procedures listed below are for the LH side.
  1. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY 
    1. Attach the 2 claws to install the regulator switch.
  2. INSTALL REAR DOOR ARMREST BASE PANEL ASSEMBLY 
    1. Connect the connector.
      Fig 1: Identifying Rear Door Armrest Base Panel Assembly
      G05636357Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Attach the 7 claws to install the armrest base panel.
      Fig 2: Identifying Armrest Base Panel & Claws
      G05636360Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.