2008 Toyota Highlander HybridFACTORY OEM SERVICE PROCEDURE

Quick Lookups: Fluids

FLUID CAPACITIES
Fluid Type Application Standard Metric Fluid Spec Note S/H
Air Cond Compressor Oil Gas/Electric 4.80 OZS. 0.14 L POE ND-OIL 11 Approximate capacity. S
Air Cond Compressor Oil w/Rear A/C 7.70 OZS. 0.22 L PAG 46 Approximate capacity. S
Air Cond Refrigerant w/o Rear A/C 1.35 LBS. 0.61 KG R-134a Approximate capacity. S
Air Cond Refrigerant w/Rear A/C 1.70 LBS. 0.77 KG R-134a Approximate capacity. S
Automatic Transmission Fluid Hybrid,Hybrid Limited Front 4.10 QTS. 3.88 L TOYOTA Genuine Automatic Transmission Fluid Type WS S
Automatic Transmission Fluid Hybrid,Hybrid Limited Rear 1.90 QTS. 1.79 L TOYOTA Genuine Automatic Transmission Fluid Type WS S
Brake Fluid N/A N/A DOT 3 Brake Fluid S
Engine Coolant 3.3L Eng Power Control Unit 3.60 QTS. 3.4 L TOYOTA Super Long Life Coolant or equivalent DO NOT use plain water alone. S
Engine Coolant 3.3L Eng w/o Rear Heater 11.20 QTS. 10.59 L TOYOTA Super Long Life Coolant or equivalent DO NOT use plain water alone. S
Engine Coolant 3.3L Eng w/Rear Heater 13.50 QTS. 12.77 L TOYOTA Super Long Life Coolant or equivalent DO NOT use plain water alone. S
Engine Oil 3.3L Eng Drain and Refill,w/Filter 5.00 QTS. 4.73 L SAE 5W-20 or 0W-20 Synthetic Oil SAE 0W-20 Synthetic Oil is the oil that provides the optimal level of fuel efficiency. S
Engine Oil 3.3L Eng Drain and Refill,w/o Filter 4.80 QTS. 4.54 L SAE 5W-20 or 0W-20 Synthetic Oil SAE 0W-20 Synthetic Oil is the oil that provides the optimal level of fuel efficiency. S
Fuel Tank 3.3L Eng 17.20 GALS. 65.1 L S
Transfer Case Fluid 1.00 QTS. 0.94 L API - GL-5 Hypoid Gear Oil, SAE 90 Above 0Deg.F (-18Deg C), SAE 80W or 80W-90 Below 0Deg. F (-18Deg C) S
Windshield Washer Fluid N/A N/A Plain water In cold areas where temperatures range below the freezing point, use washer fluid containing antifreeze. Not radiator antifreeze. S
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.