2008 Toyota Highlander HybridFACTORY OEM SERVICE PROCEDURE

VVT Sensor: Removal

  1. REMOVE COOL AIR INTAKE DUCT SEAL  (See REMOVAL )
  2. REMOVE NO. 2 ENGINE ROOM SIDE COVER LH  (See REMOVAL )
  3. REMOVE AIR CLEANER CAP SUB-ASSEMBLY  (See REMOVAL )
  4. REMOVE VVT SENSOR (for Bank 1) 
    1. Disconnect the VVT sensor connector.
    2. Remove the bolt, and then remove the VVT sensor.
      Fig 1: Locating VVT Sensor Bolt And Connector (For Bank 1)
      G05625729Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. REMOVE VVT SENSOR (for Bank 2) 
    1. Disconnect the heated oxygen sensor connector (Bank 2) from the wire harness bracket.
      Fig 2: Locating Heated Oxygen Sensor Connector (For Bank 2)
      G05625730Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disconnect the VVT sensor connector.
    3. Remove the bolt, and then remove the VVT sensor.
    Fig 3: Locating VVT Sensor Bolt And Connector (For Bank 2)
    G05625731Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.