2008 Toyota Highlander HybridFACTORY OEM SERVICE PROCEDURE

SFI System: Precaution

NOTE:
  • Be careful because the fan may operate if the A/C switch is turned on or if the engine or inverter coolant becomes hot while the power switch is on (IG or READY) and the engine is stopped.
  • When disconnecting the negative (-) battery cable, initialize the following systems after the terminal is reconnected.
SYSTEM REFERENCE

System See Procedure
SFI System INITIALIZATION 
Power Window Control System INITIALIZATION
  1. PRECAUTIONS FOR INSPECTING HYBRID CONTROL SYSTEM 
    1. Before inspecting the high-voltage system or disconnecting the low voltage connector of the inverter with converter assembly, take safety precautions such as wearing insulated gloves and removing the service plug grip to prevent electrical shocks. After removing the service plug grip, put it in your pocket to prevent other technicians from accidentally reconnecting it while you are working on the high-voltage system.
      NOTE: After removing the service plug grip, turning the power switch on (READY) may cause a malfunction. Do not turn the power switch on (READY) unless instructed by the repair information.
    2. After disconnecting the service plug grip, wait for at least 5 minutes before touching any of the high-voltage connectors or terminals.
      Fig 1: Identifying Rear Door Scuff Plate LH
      G05625020Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      HINT:

      Waiting for at least 5 minutes is required to discharge the high-voltage capacitor inside the inverter with converter assembly.

    3. After removing the inverter cover, wrap the interlock round terminal for the inverter cover with vinyl tape to prevent it from shorting to ground.
      NOTE: Do not turn the power switch on (READY) with the inverter cover removed.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.