Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Toyota Highlander HybridFACTORY OEM SERVICE PROCEDURE
Inspection Mode Procedure
HINT:
Before reading the Data List or performing the Active Tests using the Techstream, be sure to put the system into inspection mode using the following procedure.
- ACTIVATING INSPECTION MODEΒ
- Perform the following steps (1) through (4) in 60 seconds.
- Turn the power switch on (IG).
- Fully depress the accelerator pedal twice with the transmission in the P position.
- Fully depress the accelerator pedal twice with the transmission in the N position.
- Fully depress the accelerator pedal twice with the transmission in the P position.
- Check that "FWD MAINTENANCE MODE" is displayed on the multi-information display and the master warning light is illuminated in the combination meter.
- Turn the power switch on (READY).
- Perform the following steps (1) through (4) in 60 seconds.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
