2008 Toyota Highlander HybridFACTORY OEM SERVICE PROCEDURE

Related DTCS

DTC MONITORING ITEM CHART

DTC No. Monitoring Item
P043E 0.02 inch orifice low flow
P043F 0.02 inch orifice high flow
P0441
  • Purge VSV stuck close
  • Purge VSV stuck open
  • Insufficient purge flow
P1420 0.02 inch leak from canister
P1421 Gross leak from canister
P1422 0.02 inch leak from fuel tank
P1423 Gross leak from fuel tank
P2401 Vacuum pump stuck OFF
P2402 Vacuum pump stuck ON
P2419 Vent valve stuck ON (close)
P2420 Vent valve stuck OFF (vent)
P2450 Fuel vapor-containment valve stuck open
P2451 Fuel vapor-containment valve stuck close
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.