Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Inspection Procedure
- CHECK DTC
- Clear the DTCs (See DTC CHECK / CLEAR ).
- Turn the power switch off.
- Disconnect the cable from the negative battery terminal and wait for 1 minute.
- Connect the cable to the negative battery terminal.
- Turn the power switch on (IG).
- Check for DTCs.
Result
RESULT CHARTDisplay (DTC Output) Proceed to No output A P060B B P060B and P0327, P0328, P032C, P032D, P0332, P0333, P033C, P033D C B: REPLACE HYBRID VEHICLE CONTROL ECU (See REMOVAL )
C: GO TO DTC (P0327, P0328, P0332, P0333 and P033D) (See DTC P0327 KNOCK SENSOR 1 CIRCUIT LOW INPUT (BANK 1 OR SINGLE SENSOR); DTC P0328 KNOCK SENSOR 1 CIRCUIT HIGH INPUT (BANK 1 OR SINGLE SENSOR); DTC P0332 KNOCK SENSOR 2 CIRCUIT LOW INPUT (BANK 2); DTC P0333 KNOCK SENSOR 2 CIRCUIT HIGH INPUT (BANK 2) )
A: CHECK FOR INTERMITTENT PROBLEMS (See CHECK FOR INTERMITTENT PROBLEMS )
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
