2008 Toyota Highlander HybridFACTORY OEM SERVICE PROCEDURE

Inspection Procedure

  1. CHECK DTC 
    1. Clear the DTCs (See DTC CHECK / CLEAR ).
    2. Turn the power switch off.
    3. Disconnect the cable from the negative auxiliary battery terminal and wait for 1 minute.
    4. Connect the cable to the negative auxiliary battery terminal.
    5. Turn the power switch on (IG).
    6. Check for DTCs.

      OK: P060A is not present. 

    NG: REPLACE HYBRID VEHICLE CONTROL ECU  (See REMOVAL )

    OK: CHECK FOR INTERMITTENT PROBLEMS  (See CHECK FOR INTERMITTENT PROBLEMS  )

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.