2008 Toyota Highlander HybridFACTORY OEM SERVICE PROCEDURE

DTC P060A Internal Control Module Monitoring Processor Performance: Description

The main CPU and sub CPU of the ECM (included in the hybrid vehicle control ECU) perform data communication between each other. The main CPU monitors the communications and WDC pulses from the sub CPU. When the signal malfunctions below are detected, a DTC is output.

DTC TROUBLE DETECTION CONDITION CHART

DTC No. DTC Detection Condition Trouble Area
P060A When either condition below is met:
  • Hybrid vehicle control ECU main CPU error
  • Hybrid vehicle control ECU sub CPU error
  • Electronic throttle monitoring CPU error
Hybrid vehicle control ECU
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.