Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Inspection Procedure
- CHECK FOR EXHAUST GAS LEAKÂ
- Allow the engine to idle.
- Check for exhaust gas leaks around the heated oxygen sensor.
OK: No leaks from the heated oxygen sensor.Â
NG: REPAIR OR REPLACE EXHAUST GAS LEAK POINTÂ (See ON-VEHICLE INSPECTION )
OK: Go to Next StepÂ
- INSPECT HEATED OXYGEN SENSORÂ
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Start the engine and warm it up.
- Allow the engine to idle.
- Select the following menu items: Powertrain / Engine and ECT Active Test / Control the Injection Volume for A/F Sensor.
- Check the O2S B1S2 values when the Control the Injection Volume for A/F Sensor is - 12.5% (Lean fuel-trim).
- Check the O2S B1S2 values when the Control the Injection Volume for A/F Sensor is 25% (Rich fuel-trim).
Standard voltageÂ
VOLTAGE SPECIFICATIONControl the Injection Volume for A/F Sensor O2S B1S2 -12.5% Less than 0.2 V 25% More than 0.8 V NG: REPLACE HEATED OXYGEN SENSORÂ (See HEATED OXYGEN SENSORÂ )
OK: Go to Next StepÂ
- CHECK WHETHER DTC OUTPUT RECURS (DTC P0607)Â
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Clear the DTC (See DTC CHECK / CLEARÂ ).
- Turn the power switch to off and turn the Techstream off.
- Disconnect the Techstream.
- Disconnect the cable from the battery negative (-) terminal and wait for 1 minute.
- Connect the cable to the battery negative (-) terminal.
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Start the engine.
- Perform the drive pattern.
- Warm up the engine.
- Accelerate the vehicle until 80 km/h (50 mph) and stop the vehicle.
- Drive the vehicle by 60 to 80 km/h (35 to 50 mph) for 5 minutes or more.
- Select the following menu items: Powertrain / Engine and ECT / Trouble Codes.
- Read the DTCs.
ResultÂ
RESULT CHARTResult Proceed to No output A P0607 B B: REPLACE HYBRID VEHICLE CONTROL ECUÂ (See REMOVAL )
A: CHECK FOR INTERMITTENT PROBLEMSÂ (See CHECK FOR INTERMITTENT PROBLEMSÂ )
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
