Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Toyota Highlander HybridFACTORY OEM SERVICE PROCEDURE
Check Mode Procedure
HINT:
Compared to normal mode, check mode is more sensitive to malfunctions. Therefore, check mode can detect the malfunctions that cannot be detected in normal mode.
NOTE:
All the stored DTCs and freeze frame data are erased if: 1) the ECM (included in the hybrid vehicle control ECU) is changed from normal mode to check mode or vice versa: or 2) the power switch on (IG) is turned from on to ACC or off while in check mode. Before changing modes, always check and make a note of any DTCs and freeze frame data.
- CHECK MODE PROCEDURE
- Check and ensure the following conditions:
- Battery positive voltage 11 V or more.
- Transmission in the P position.
- A/C switched OFF.
- Turn the power switch off.
- Connect the Techstream to the DLC3.
- Turn the power switch on (READY).
- Turn the Techstream on.
- Enter the following menus: Powertrain / Engine and ECT / Utility / Check Mode.
- Switch the ECM (included in the hybrid vehicle control ECU) from normal mode to check mode.
- Make sure that the MIL flashes as shown in the illustration.
- Turn the power switch on (READY).
- Make sure that tne MIL turns OFF.
- Simulate the conditions of the malfunction described by the customer.
- Check the DTCs and freeze frame data using the Techstream.
- Check and ensure the following conditions:
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
