2008 Toyota Highlander HybridFACTORY OEM SERVICE PROCEDURE

Integration Relay: Inspection

  1. INSPECT ENGINE ROOM JUNCTION BLOCK ASSEMBLY 
    Fig 1: Integration Relay Circuit Diagram
    G05625781Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Inspect the EFI No. 1 fuse.
      1. Remove the EFI No. 1 fuse.
      2. Using an ohmmeter, measure the resistance of the fuse.

        Standard resistance 

      TESTER CONNECTION SPECIFIED CONDITION

      Tester Connection Condition Specified Condition
      EFI No. 1 fuse Always Below 1 Ω
    2. Inspect the A/F fuse.
      1. Remove the A/F fuse.
      2. Using an ohmmeter, measure the resistance of the fuse.

        Standard resistance 

      TESTER CONNECTION SPECIFIED CONDITION

      Tester Connection Condition Specified Condition
      A/F fuse Always Below 1 Ω
    3. Inspect the C/OPN relay.
      1. Measure the resistance according to the value (s) in the table below.

        Standard resistance 

        TESTER CONNECTION SPECIFIED CONDITION

        Tester Connection Condition Specified Condition
        2E-13 - 2E-6 No battery voltage applied 10 kΩ or higher
        2E-13 - 2E-6 Battery voltage applied to terminals 2E-6 and 2D-12 Below 1 Ω
        NOTE: While using the battery for the inspection, do not bring the positive and negative tester probes too close to each other as a short circuit may occur.
      Fig 2: Identifying C/OPN Relay
      G05625782Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Inspect the A/F relay.

      (1) Measure the resistance according to the value (s) in the table below. Standard resistance 

      TESTER CONNECTION SPECIFIED CONDITION

      Tester Connection Condition Specified Condition
      2A-4 - 2C-1 No battery voltage applied 10 kΩ or higher
      2A-4 - 2C-1 Battery voltage applied to terminals 2E-10 and 2E-6 Below 1 Ω
      NOTE: While using the battery for the inspection, do not bring the positive and negative tester probes too close to each other as a short circuit may occur.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.