Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Toyota Highlander HybridFACTORY OEM SERVICE PROCEDURE
Engine Coolant Temperature Sensor: Removal
- REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LHÂ (See REMOVAL )
- REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RHÂ (See REMOVAL )
- REMOVE HOOD TO COWL TOP SEALÂ (See REMOVAL )
- REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLYÂ (See REMOVAL )
- REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLYÂ (See REMOVAL )
- REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLYÂ (See REMOVAL )
- REMOVE COOL AIR INTAKE DUCT SEALÂ (See REMOVAL )
- REMOVE NO. 2 ENGINE ROOM SIDE COVER LHÂ (See REMOVAL )
- REMOVE AIR CLEANER CAP SUB-ASSEMBLYÂ (See REMOVAL )
- REMOVE AIR CLEANER CASE SUB-ASSEMBLYÂ (See REMOVAL )
- REMOVE AIR CLEANER BRACKETÂ (See REMOVAL )
- REMOVE ENGINE COOLANT TEMPERATURE SENSORÂ
- Disconnect the engine coolant temperature sensor connector.
- Remove the engine coolant temperature sensor and gasket.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
