2008 Toyota Highlander HybridFACTORY OEM SERVICE PROCEDURE

Crankshaft Position Sensor: Installation

  1. INSTALL CRANKSHAFT POSITION SENSOR 
    1. Apply a light coat of engine oil to the O-ring on the crankshaft position sensor.
    2. Install the crankshaft position sensor with the bolt.

      Torque: 8.0 N*m (80 kgf*cm, 71 in.*lbf) 

    3. Connect the crankshaft position sensor connector.
    4. Fig 1: Locating Crankshaft Position Sensor With Bolt
      G05245825Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL FRONT FENDER APRON SEAL RH 
  3. INSTALL FRONT FENDER LINER RH 
  4. INSTALL NO. 1 ENGINE UNDER COVER  (See INSTALLATION )
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.