Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Toyota Highlander Base, FWDFACTORY OEM SERVICE PROCEDURE
Recommended Tools
RECOMMENDED TOOLS
| 09010-3C100 | Set, Hexagon Wrench | |
| (09013-6C140) | Socket Hexagon 12 mm | |
| 09010-3C120 | Set, "TORX" Socket Wrench | |
| (09013-1C130) | "TORX" Socket Wrench T-type T40 | |
| 09013-7C120 | Straight Hexagon 14 mm | |
| 09013-7C400 | Wrench Set | |
| 09061-1C300 | Set, Molding Remover | |
| (09061-1C340) | Remover D, Molding | |
| 09082-00050 | TOYOTA Electrical Tester Set | |
| 09904-00010 | Expander Set | |
| (09904-00050) | No. 4 Claw |
HINT:
TORX is a registered trademark of Textron Inc.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
