Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic Trouble Code Chart
HINT:
If a malfunction code is displayed during the DTC check, check the circuit indicated by the DTC.
DTC chart of ABS:
| DTC Code | Detection Item | Trouble Area |
|---|---|---|
| C0200/31 *1 | Front Speed Sensor RH Circuit |
|
| C0205/32 *1 | Front Speed Sensor LH Circuit |
|
| C0210/33 *1 | Rear Speed Sensor RH Circuit |
|
| C0215/34 *1 | Rear Speed Sensor LH Circuit |
|
| C0226/21 | SFR Solenoid Circuit |
|
| C0236/22 | SFL Solenoid Circuit |
|
| C0246/23 | SRR Solenoid Circuit |
|
| C0256/24 | SRL Solenoid Circuit |
|
| C0273/13 *1 | Open in ABS Motor Relay Circuit |
|
| C0274/14 | Short to B+ in ABS Motor Relay Circuit |
|
| C0278/11 | Open in ABS Solenoid Relay Circuit |
|
| C0279/12 | Short to B+ in ABS Solenoid Relay Circuit |
|
| C1225/25 | SM Solenoid Circuit |
|
| C1235/35 | Foreign Object is Attached on Tip of Front Speed Sensor RH |
|
| C1236/36 | Foreign Object is Attached on Tip of Front Speed Sensor LH |
|
| C1238/38 | Foreign Object is Attached on Tip of Rear Speed Sensor RH |
|
| C1239/39 | Foreign Object is Attached on Tip of Rear Speed Sensor LH |
|
| C1241/41 | Low Battery Positive Voltage |
|
| C1243/43 *1 | Acceleration Sensor Stuck Malfunction |
|
| C1244/44 | Open or Short in Acceleration Sensor Circuit |
|
| C1245/45 *1 | Acceleration Sensor Output Malfunction |
|
| C1246/46 *2 | Master Cylinder Pressure Sensor Malfunction |
|
| C1249/49 | Open in Stop Light Switch Circuit |
|
| C1251/51 *1 | Open in Pump Motor Circuit |
|
| C1361/91 | Short Circuit in ABS Motor Fail Safe Relay Circuit |
|
| C1381/97 | Yaw Rate and / or Acceleration Sensor Power Supply Voltage Malfunction |
|
| U0073/94 | Control Module Communication Bus OFF |
|
| U0124/95 | Lost Communication with Lateral Acceleration Sensor Module |
|
| *1, *2: Even after the trouble areas are repaired, the ABS warning light will not go off unless the following operations are performed. *1:
*2:
|
||
HINT:
- In some cases, Techstream cannot be used when the ABS warning light remains on.
- When U0073/94, U0123/62, U0124/95 or U0126/63 are output, inspect and repair the trouble areas indicated by U0073/94, U0123/62, U0124/95 or U0126/63 first.
DTC chart of VSC:
DTC CHART OF VSCDTC Code Detection Item Trouble Area C1201/51 Engine Control System Malfunction Engine control system C1203/53 ECM Communication Circuit Malfunction - TRC+ or TRC- circuit
- ENG+ or ENG- circuit
- ECM
C1210/36 Zero Point Calibration of Yaw Rate Sensor Undone - Yaw rate and acceleration sensor
- Zero point calibration undone
C1223/43 ABS Control System Malfunction ABS control system C1224/44 NE Signal Circuit - NEO circuit
- ECM
- Skid control ECU
C1231/31 Steering Angle Sensor Circuit Malfunction - Steering angle sensor
- Steering angle sensor circuit
- CAN communication system
C1232/32 Stuck in Acceleration Sensor - Yaw rate and acceleration sensor
- Yaw rate and acceleration sensor circuit
- CAN communication circuit
C1234/34 Yaw Rate Sensor Malfunction - Yaw rate and acceleration sensor
- Yaw rate and acceleration sensor circuit
- CAN communication circuit
C1336/39 Zero Point Calibration of Acceleration Sensor Undone - Yaw rate and acceleration sensor
- Zero point calibration undone
U0100/65 Lost Communication with ECM / PCM - Wire harness
- ECM
U0123/62 Lost Communication with Yaw Rate Sensor Module - Wire harness
- Yaw rate and acceleration sensor
U0126/63 Lost Communication with Steering Angle Sensor Module - Wire harness
- Steering angle sensor
Test mode DTC of ABS:
TEST MODE DTC OF ABSDTC Code Detection Item Trouble Area C1271/71 Low Output Signal of Front Speed Sensor RH (Test Mode DTC) - Front speed sensor RH
- Sensor installation
- Sensor rotor
C1272/72 Low Output Signal of Front Speed Sensor LH (Test Mode DTC) - Front speed sensor LH
- Sensor installation
- Sensor rotor
C1273/73 Low Output Signal of Rear Speed Sensor RH (Test Mode DTC) - Rear speed sensor RH
- Sensor installation
- Sensor rotor
C1274/74 Low Output Signal of Rear Speed Sensor LH (Test Mode DTC) - Rear speed sensor LH
- Sensor installation
- Sensor rotor
C1275/75 Abnormal Change in Output Signal of Front Speed Sensor RH (Test Mode DTC) Front sensor rotor RH C1276/76 Abnormal Change in Output Signal of Front Speed Sensor LH (Test Mode DTC) Front speed sensor rotor LH C1277/77 Abnormal Change in Output Signal of Rear Speed Sensor RH (Test Mode DTC) Rear sensor rotor RH C1278/78 Abnormal Change in Output Signal of Rear Speed Sensor LH (Test Mode DTC) Rear speed sensor rotor LH C1279/79 Acceleration Sensor Output Voltage Malfunction (Test Mode DTC) - Yaw rate and acceleration sensor
- Sensor installation
C1281/81 Master Cylinder Pressure Sensor Output Malfunction (Test Mode DTC) Master cylinder pressure sensor Test mode DTC of VSC:
TEST MODE DTC OF VSCDTC Code Detection Item Trouble Area C0371/71 Yaw Rate Sensor (Test Mode DTC) Yaw rate sensor
HINT:
In some cases, Techstream cannot be used when the VSC warning light remains on.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
