2008 Toyota Corolla LE, AutomaticFACTORY OEM SERVICE PROCEDURE

Skid Control Sensor: Removal

HINT:

Replace the RH side by the same procedure as the LH side.

  1. REMOVE REAR WHEEL 
  2. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY (for Drum Type, TMMC Made)  (See DISASSEMBLY )
  3. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY (for Drum Type, TMC Made)  (See DISASSEMBLY )
  4. DISCONNECT SKID CONTROL SENSOR WIRE 
    1. Disconnect the skid control sensor wire connector from the skid control sensor.
  5. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY LH  (See REMOVAL )
    Fig 1: Identifying Skid Control Sensor Wire Connector
    G05194990Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE SKID CONTROL SENSOR 
    1. Mount the rear axle hub in a soft jaw vise.
      NOTE: Replace the axle hub assembly if it is dropped or a strong shock is given to it.
    2. Using a pin punch and hammer, drive out the 2 pins and remove the 2 attachments from SST.
    3. Using SST and 2 bolts (Diameter: 12 mm, pitch: 1.5 mm), remove the skid control sensor from the rear axle hub.

      SST 09520-00031 (09520-00040), 09521-00020, 09950-00020 

      NOTE:
      • If a damage is inflicted to the sensor rotor, replace the axle hub assembly.
      • Do not scratch the contacting surface of axle hub and speed sensor.
        Fig 2: Identifying Skid Control Sensor From Rear Axle Hub
        G05235350Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.