Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Toyota Corolla LE, AutomaticFACTORY OEM SERVICE PROCEDURE
Front Speed Sensor: Removal
HINT:
Replace the RH side by the same procedure as the LH side.
- REMOVE FRONT WHEEL
- REMOVE FRONT FENDER LINER LH
- REMOVE SPEED SENSOR FRONT LH
- Disengage the speed sensor wire harness clamp from the body.
- Disconnect the speed sensor connector.
- Remove the 2 clamp bolts holding the sensor harness from the body and shock absorber.
- Remove the bolt and speed sensor front LH.NOTE: Keep on the sensor tip clean.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
