2008 Toyota Corolla LE, AutomaticFACTORY OEM SERVICE PROCEDURE

Deceleration Sensor: Removal

  1. REMOVE FRONT SEAT ASSEMBLY LH  (See REMOVAL )
  2. REMOVE DECELERATION SENSOR BRACKET 
    1. Remove the bolt and upper side deceleration sensor bracket.
      Fig 1: Identifying Deceleration Sensor Bracket Bolt
      G05194997Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE DECELERATION SENSOR 
    1. Disconnect the deceleration sensor connector from the deceleration sensor, then remove the 2 bolts and deceleration sensor with the anchor side deceleration sensor bracket.
      Fig 2: Identifying Yaw Rate And Acceleration Sensor Assembly Bolts
      G05194998Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.