2008 Toyota Corolla LE, AutomaticFACTORY OEM SERVICE PROCEDURE

Test Mode Procedure

  1. WARNING LIGHT BULB CHECK 
    NOTE: When releasing the parking brake, set the chocks to hold the vehicle for safety.

    HINT:

    When the parking brake is applied or the level of the brake fluid is low, the BRAKE warning light comes on.

    1. Release the parking brake lever.
    2. Check that the ABS warning light and BRAKE warning light come on when the ignition switch is turned on and will go off in about 3 seconds.
    3. If the warning lights do not come on, or remain on, the bulb has burned out or the skid control ECU may be defective.
  2. SENSOR SIGNAL CHECK (TEST MODE) (USING TECHSTREAM) 

    If the ignition switch is turned from the ON to the ACC or LOCK position during test mode, DTCs of the sensor check function will be erased.

    1. Procedures for sensor signal check
      1. Turn the ignition switch off.
      2. Check that the shift lever is in the P position.
      3. Connect Techstream to the DLC3.
      4. Start the engine.
      5. Operate Techstream in test mode (Signal Check).
        Fig 1: Identifying ABS And BRAKE Warning Light
        G05194760Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      6. Check that the ABS warning light blinks.

        HINT:

        If the ABS warning light does not blink, inspect the ABS warning light circuit.

        SYMPTOM CHART

        Trouble Area See procedure
        ABS warning light circuit ABS WARNING LIGHT DOES NOT COME ON 
    2. Start the sensor signal check.
      1. Drive vehicle straight forward.

        Drive the vehicle at a speed of 28 mph (45 km/h) or higher for several seconds and check that the ABS warning light goes off.

        Fig 2: Identifying Blinking Pattern Of ABS Warning Light In Test Mode
        G05194763Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.