Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Toyota Corolla LE, AutomaticFACTORY OEM SERVICE PROCEDURE
Freeze Frame Data
- FREEZE FRAME DATAÂ
HINT:
- Whenever a DTC is detected or the ABS operates, the skid control ECU stores the current vehicle (sensor) state as freeze frame data.
- The skid control ECU stores the number of times (maximum: 31) the ignition switch has been turned from off to the ON position since the last time the ABS was activated. However, if the vehicle was stopped or at a low speed (4.3 mph (7 km/h) or less), or if a DTC is detected, the skid control ECU will not count the number since then.
- Freeze frame data at the time the ABS operates: The skid control ECU stores and updates data whenever the ABS system operates.
When the ECU stores data at the time a DTC is detected, the data stored when the ABS operated is erased.
- Freeze frame data at the time a DTC is detected: When the skid control ECU stores data at the time a DTC is detected, no updates will be performed until the data is cleared.
- Connect Techstream to the DLC3.
- Turn the ignition switch to the ON position.
- From the display on the tester, select the Freeze Frame Data.
ABS/VSC/TRAC:Â
ABS/VSC/TRACTester Display Measurement Item Reference Value Stop Light SW Stop light switch signal Stop light switch ON: ON, OFF: OFF Operated System System status ABS activated: ABS, BA, NO SYS, FAIL SAFE Number of IG ON Numbers of operations of ignition switch ON after memorizing freeze frame data 0 to 31 Vehicle Speed Vehicle speed Min.: 0 mph (0 km/h)
Max.: 202 mph (326 km/h)Vehicle Speed Grade Vehicle speed grade Min.:-1.869 G, Max.: 1.869 G
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
